 Lamps
can achieve very interesting and striking effects by flashing
the lamps at
regular intervals or dimming the lamps. Power Supply Control interfaces
can accomplish this. They connect to the Power supplies
(all 600, 2200 , and 12K models) externally via a Molex™
Mini-Fit 6 pin connector and all share the following properties:
Dimensions: 3” x 2” x 1” Cable lengths: 20”
Operating Temp: -40C to +85C
Case: Black Thermoplastic |
Variable Flashing Module CMD-004
Two flush-set screwdriver pots (dials) are used to
manually adjust the “On” time and the “Off”
time of the flashing lamp. Both times independently
may be set to anywhere from 0.5 seconds
to 9 seconds. The cable comes in a standard
20” length, but the module will work up
to 100’ away from the power supply if replaced
with a longer custom cable. |
|
Manual Dimming Module CMD-002A rotary dimmer switch
is used to manually dim the lamp. The cable comes in a standard
20” length, but the module will work up to 100’
away from the power supply if replaced with a
longer custom cable. |
|
Analog Interface Module CMD-001
Remote control interface enables on-board dimming of lamp via
interface with Power Supplies. |
|
